Arkadaşlar herkese iyi forumlar. 16F877A VE HC-05 kullanarak okuduğum bir değeri bluetooth ile mobil uygulamada görüntülemeye çalışıyorum ama bir türlü çalıştıramadım. Bluetooth ile led yak-söndür yapabiliyorum modülde bir sıkıntı yok yani. İlk önce B0'a bağlı butona basarak data değişkenini arttırıp bu değeri görüntülemek istedim.
4MHz'lik osilatör kullanıyorum. Kullandığım derleyici ise MPLAB XC8.
Kod:
#pragma config FOSC = XT // Oscillator Selection bits (XT oscillator)
#pragma config WDTE = OFF // Watchdog Timer Enable bit (WDT disabled)
#pragma config PWRTE = OFF // Power-up Timer Enable bit (PWRT disabled)
#pragma config BOREN = OFF // Brown-out Reset Enable bit (BOR disabled)
#pragma config LVP = OFF // Low-Voltage (Single-Supply) In-Circuit Serial Programming Enable bit (RB3 is digital I/O, HV on MCLR must be used for programming)
#pragma config CPD = OFF // Data EEPROM Memory Code Protection bit (Data EEPROM code protection off)
#pragma config WRT = OFF // Flash Program Memory Write Enable bits (Write protection off; all program memory may be written to by EECON control)
#pragma config CP = OFF // Flash Program Memory Code Protection bit (Code protection off)
// #pragma config statements should precede project file includes.
// Use project enums instead of #define for ON and OFF.
#include <xc.h>
#include <stdint.h>
#define _XTAL_FREQ 4000000
void UART_TX_Init(void);
void UART_Write(uint8_t);
void main(void)
{
UART_TX_Init(); // Initialize The UART in Master Mode @ 9600bps
uint8_t Data = 0;
TRISB = 1;
RB7 = 0;
while(1) {
if (RB0 == 1) {
RB7 = 1;
Data++;
__delay_ms(250);
}
else {
RB7=0;
}
}
UART_Write(Data);
return;
}
void UART_TX_Init(void)
{
BRGH = 1; // Set For High-Speed Baud Rate
SPBRG = 25; // Set The Baud Rate To Be 9600 bps
//--[ Enable The Ascynchronous Serial Port ]--
SYNC = 0;
SPEN = 1;
//--[ Set The RX-TX Pins to be in UART mode (not io) ]--
TRISC6 = 1; // As stated in the datasheet
TRISC7 = 1; // As stated in the datasheet
TXEN = 1; // Enable UART Transmission
}
void UART_Write(uint8_t data)
{
while(!TRMT);
TXREG = data;
}
Şimdiden teşekkür ediyorum. İyi forumlar.